8.顯示器接受上壓板頂?shù)膲毫Ω袘?yīng)器之信號，顯示當時*大壓力值。按下清零鍵，可**顯示器上的數字。按下峰值鍵，在測試時可記錄下測試的*大值。
1．1 Application：
l This machine adopts high precision sensor induction，Also test paper and cardboard ring crush strength, vertical compressive strength, bonding strength and flat crush strength test tensile strength test value and direct display.
2. Principium：
Electronic display ring crush / tensile testing machine, the machine to use the motor drive screw of fixture mobile device good sample test fixture is placed between the upper and lower fixture, then administered the prescribed speed on the fixture down compression specimens when fixture on the upper end of the load cell pressure is felt; pull test to move up on the fixture the lower clamp down mobile same fixture feel the pressure, and force is converted into a voltage signal lost to display results used in conjunction lOAD CELL forces sensor connected to the monitor automatically display the power of values??.
3、Test specifications
5.1Instructions：
1.The machine must be connected to the power supply of 220V +5% 50HZ, have a good grounding protection measures.
2.Open the power switch on the front panel, the panel was electric, the display will automatically open the program.
3.The machine recognized stroke protection device are effective or reasonable.
4.The test sample is placed in the middle fixture according to the thickness of the sample, the diameter of the inner disk placed in the seat of the sample (inner disk labeled for specimen thickness in mm), carefully inserted into the sample holder of the samples, and to ensure that the plugin the end the Ministry as shown, press the test button and increase or decrease key to start the test.
5.Direct contact, or non-vertical jig metal specimen test.
6.In the testing process, if the abnormal condition, press the Stop button, turn off the power immediately notify maintenance personnel to detect. Before use upon Troubleshooting.
7.Printer to accept the display signal, press the print button to print the current date, time, number of times and the maximum pressure value. (Detailed operation see the operation of the monitor operation and printer)
8.The monitor accepts a signal of the pressure sensor on the platen top, showing that the maximum pressure value. Press the Clear key to clear the display on the digital. Peak key is pressed, and tested under the maximum can be recorded in the test.
